User's Manual

OPERATION
1. Turn on the wall switch to activate the fitting, the fitting is now under Nighttime mode: light works at night and
camera works all day. You will be able to view what the camera sees with the handheld LCD Monitor.
The camera operates 24 hours a day and is not controlled by the PIR sensors.
NOTE: Allow for approximately 30 seconds warm-up time before the sensor resumes normal activity.
2. To test, walk through the sensor’s detection area.
3. Movement will activate the sensor and turn the light on, the light and camera will turn to face to the detected zone.
the light will operate for the programmed time(30/60seconds). You will be able to see what or who has caused the PIR to
activate with the handheld LCD Monitor.
4. After the PIR is activated, keep out of detection area and the light will switch off automatically after the programmed time
(30/60 seconds). The light will be activated again when detecting any further movement.
If there is continuing movement in the detection zone, the light will stay on until movement ceases-after the programmed time
NOTE: THE INTELLIGENT MOTION SENSOR TRACKING LIGHT IS DESIGNED TO ILLUMINATE
WHEN THE DETECTION AREA IS ENTERED BY A PERSON AND WILL DETECT MOVING HEAT
SOURCE. THERE IS NO GUARANTEE IMPLIED THAT IT WILL PROVIDE TOTAL SECURITY OR
PREVENT ILLEGAL ENTRY.
SPECIFICATION
Detection Method: Passive Infrared Sensor (with continuously detect function)
Sensor Range: 33ft (10 m) x 210° (maximum)
Camera: Color CMOS image sensor
View angle 60°
Transmission frequency: ISM 2.4GHz ARIB-T66
Power source: AC 100V-240V 50/60Hz
Time adjustment: 30 / 60 seconds
Sensitivity adjustment: 5m / 10m
OperationTemperature:0℃~+50℃
Left 70° Right 70°
Hidden LED indicator
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter.