AMISCL2 STEREO COMPRESSOR LIMITER INSTALLATION & OPERATION MANUAL
INTRODUCTION AND CONTENTS The Australian Monitor Pro Series AMISCL2 is a 1 RU, dual channel compressor limiter. Featuring an expander/gate, compression and limiting per channel, the AMISCL2 utilises a high quality VCA to give excellent performance from a budget priced dynamics processor.
FRONT PANEL 1 3 2 14 1 POWER SWITCH This switches the mains power "on" to the unit. 2 COMPRESSOR/LIMITER SECTION Refer to inset box immediately opposite. 3 EXPANDER/GATE THRESHOLD This control adjusts the threshold level of the expander/gate within a range from off (bypass) to +10dB. The Red LED glows when expansion occurs.
REAR PANEL 15 21 22 23 15 CHANNEL DETAIL Refer to inset box below. 21 MAINS VOLTAGE SELECTOR This switches mains voltage from 230VAC to 240VAC. Please ensure that this switch is set to the correct voltage for your part of the world. 16 17 18 19 20 22 FUSE HOLDER CHANNEL DETAIL 16 TRS LINE OUT 19 TRS LINE IN This 6.35mm TRS connector accepts a balanced or unbalanced line level input. This 6.35mm TRS connector is a balanced or unbalanced line level output.
SET UP AND OPERATION the threshold, the signal is reduced in level, relative to the amount the signal exceeds this point. This gain reduction is set by the ratio control. Fig 1 The interactive relationship between the operating level and the headroom It is possible to further improve the audio quality by constantly monitoring the programme material with the aid of a volume fader, which manually levels the material. During low passages the gain is increased, during loud passages the gain is reduced.
SPECIFICATIONS AUDIO INPUT Type Impedance Nominal Operating Level Maximum Input Level CMR @ 1kHz DETECTOR INPUT Type Impedance Maximum Input Level AUDIO OUTPUT Type Impedance Maximum Input Level Bandwidth THD @ +4dBu THD @ +20dBu IMD (SMPTE) @ +10dBu Noise & Hum, unity gain Noise & Hum, fully off Crosstalk @ 20kHz CMR @ 1kHz RF-filtered, Servo-balanced input stage 60KΩ balanced -10dBu to +4dBu +21dBu balanced and unbalanced >40dB DC de-coupled, unbalanced input >20KΩ +21dBu Electronically buffered outpu
AUSTRALIA AND NEW ZEALAND www.australianmonitor.com.au SYDNEY MELBOURNE BRISBANE ADELAIDE PERTH AUCKLAND (NSW & ACT SALES) (VIC & TAS SALES) (QLD SALES) (SA & NT SALES) (WA SALES) (NZ SALES) 149 Beaconsfield Street Silverwater NSW 2128 Private Bag 149 Silverwater NSW 1811 Phone: (02) 9647 1411 Fax: (02) 9648 3698 Email: nsw@audiotelex.com.au 22/277 Middleborough Road Box Hill VIC 3128 PO Box 151 Blackburn South VIC 3130 Phone: (03) 9890 7477 Fax: (03) 9890 7977 Email: vic@audiotelex.com.