DPRM REMOTE CONTROL PANEL INSTALLATION AND OPERATION MANUAL
HEADING 1. IMPORTANT SAFETY INFORMATION Save the carton and packing material even if the equipment has arrived in good condition. Should you ever need to ship the unit, use only the original factory packing. 2. Read all documentation before operating your equipment. Retain all documentation for future reference. 3. Follow all instructions printed on unit chassis for proper operation. 4. Do not spill water or other liquids into or on the unit, or operate the unit while standing in liquid. 5.
INTRODUCTION AND CONTENTS The Australian Monitor Installation Series DPRM Remote Control Panel is a control surface that is designed to be used with the DigiPage Zone Paging and Source Selection System. INTRODUCTION 3 CONTROLS 4 The DPRM allows control over program source selection, local input selection and volume control from a remote location. INSTALLATION 5 PROGRAMMING 6 LED illumination provides the user with visual feed back if the system is busy.
CONTROLS All the controls correspond only to the zone for which the panel is programmed by the installer. (see programming section) 1 PROG 1–6 This row of 6 buttons selects the numbered program source. They are electrically interlocking meaning that selecting one source will deselect the previously selected source. 1 2 PROG OFF This button will turn off the program source that is currently selected . 3 LOCAL ON/OFF This button toggles the local input on or off.
INSTALLATION The CAT5 cable connects to the screw terminals numbered 1-6. These numbers correspond to the pins of the RJ45 connector on the main unit. If following the 568A convention, the wire colours are wired as: “PIN 1” PIN WIRE COLOUR DP NETWORK 1 White/Green Ground 2 Green +18V 3 White/Orange Data+ 4 Blue Busy- 5 White/Blue Busy+ (+18V) 6 Orange Data- 7 White/Brown Spare 8 Brown Spare Ensure that the spare pair cannot short to anything.
PROGRAMMING The following steps are for programming the remote control panel for use in ZONE X: 1 Hold down the RESET button on the back. 2 While holding down the RESET button, hold down both the Up and Down volume buttons. 3 Release the RESET button. 4 The remote control panel will beep 3 times indicating it is in program mode. The BUSY LED will stay lit while in program mode. 5 Press the Up button X times (the unit will beep each time). Eg. for ZONE 4, press 4 times 6 Press the Down button.
AUSTRALIA AND NEW ZEALAND www.australianmonitor.com.au SYDNEY MELBOURNE BRISBANE ADELAIDE PERTH AUCKLAND (NSW & ACT SALES) (VIC & TAS SALES) (QLD SALES) (SA & NT SALES) (WA SALES) (NZ SALES) 149 Beaconsfield Street Silverwater NSW 2128 Private Bag 149 Silverwater NSW 1811 Phone: (02) 9647 1411 Fax: (02) 9648 3698 Email: nsw@audiotelex.com.au 22/277 Middleborough Road Box Hill VIC 3128 PO Box 151 Blackburn South VIC 3130 Phone: (03) 9890 7477 Fax: (03) 9890 7977 Email: vic@audiotelex.com.
