INSTALLATION AND OPERATION MANUAL ICON-3
IMPORTANT SAFETY INFORMATION PRÉCAUTIONS DURANT UTILISATION 1. Read these instructions. 1. LISEZ ces instructions. 2. Keep these instructions. 2. Tenez ces instructions. 3. Heed all warnings. 3. Notez tous les avertissements. 4. Follow all instructions. 4. Suivez toutes les avertissements. 5. Do not use this apparatus near water. 5. N’utilisez pas ce produit près de l’eau (la piscine, la plage, le lac, etc.). 6. Clean only with dry cloth. 6. Nettoyez seulement avec une étoffe sèche.
INTRODUCTION AND CONTENTS ICON-3 INTRODUCTION 3 The ICON-3 paging station is both elegant and ergonomic to suit today’s modern installations. FRONT PANEL 4 ICON-3 is designed for use with the Australian Monitor Zone Revolution, allowing for paging to any single zone or combination of zones, while also providing visual feedback of the selected zones paging state. CONNECTION 5 SETTINGS 6 DIMENSIONS 7 Revision 1.
FRONT PANEL 1 2 4 3 1 Microphone 3 Push To Talk This is the microphone element. It features an in-built pop-shield to reduce low frequency noise when used in close proximity. The push to talk button initiates a page to the selected paging zones. This button must be held down for the duration of the page announcement. In normal use, the ideal distance between the microphone element and the announcer’s mouth is between 100 and 200mm.
CONNECTION 1 1 CN1 This RJ45 connector provides power, data and audio signals to and from the ICON-3, for direct connection to the Zone Revolution Page ports. Each ICON-3 paging station is connected directly to the Zone Revolution in a point-to-point manner. Zone Revolution supports a maximum of 2 ICON-3 stations. When wiring the ICON-3 paging stations we suggest using straight-through pre-made cables wherever possible.
SETTINGS The ICON-3 Paging Station under side provides a single bank of DIP switches for address selection and future options. The adjustable potentiometer VR1 provides fine adjustment of the microphone audio level. SW1: Only two RS485 addresses are valid when using the ICON-3 with Zone Revolution. VR1: The adjustable trim-pot provides a method to trim the microphone audio gain to suit the intended application. By default, this level trim is set to a nominal operating level.
DIMENSIONS 221.4 mm TOP 109.0 mm 80.
ENGINEERED BY AUSTRALIAN MONITOR Address: 1 Clyde Street, Silverwater, Sydney NSW 2128 Australia. Private Bag 149, Silverwater NSW 1811 ABN 78 001 345 482 Website: www.australianmonitor.com.au International enquiries email: international@australianmonitor.com.au DISTRIBUTED IN AUSTRALIA AND NEW ZEALAND BY HILLS SVL www.hillssvl.com.au NSW P: 02 9647 1411 E: nsw@hillssvl.com.au QLD P: 07 3852 1312 E: qld@hillssvl.com.au ACT P: 02 6260 4544 E: act@hillssvl.com.au WA P: 08 9204 0200 E: wa@hillssvl.com.