Manual

PAGE 11IN600 INSTALLATION AND OPERATION MANUAL
SETUP / SOFTWARE CONTINUED
3
2
1
1
Projector Timeouts
This is the number of seconds (integer values only) that the IN600 will wait before
allowing another command to be set to the projector when an On/Off command
is sent. This allows time for the projector to warm up or cool down. Consult the
projectors manufacturer data for information on warm up and cool down times.
Integer values between 1 and 300 are accepted.
2
Projector Strings
These are the strings that will be sent to projector. When the projector power
button is pushed on the IN600 the on or off code is sent. When a source is
selected the corresponding video format code is sent.
Table 1
DVD1
DVD2
depends on setting of back panel DIP switch
AUX1
AUX2
Video code set
PC1
PC2
VGA code sent
A maximum of 20 characters can be sent. \x will cause the next 2 characters to be
read as a hex value. eg \x20 will send hex value 20 (ASCII-space).
The test buttons allow these strings to be sent to the projector. The IN600 must be
Online for these to work.
3
Screen
This is the number of seconds the SCREEN up/down relay contacts will stay closed
for controlling the screen motor. It is accurate to 0.1 seconds and accepts values
from 0.1 to 25.5.
Project Setup window
This window allows you to set the parameters of the RS232 port used to connect to a projector. You can set all the parameters of the communication protocol; Baud Rate,
Parity, No of Data Bits, No of Stop Bits.
GND
PIN 2: Receive Data
PIN 3: Transmit Data
PIN 5: Signal Ground
TxD
RxD
5
9
8
7
6
4
3
2
1
RS-232 DB-9 Male Pinout