Instruction manual

5 6
HARDWARE INSTALLATION
IN THE BOX
Your elite pack contains the following elements:
1 x mini CT Sensor
1 x Transmitter
1 x elite Wireless Energy Monitor
You will need to attach the sensor to the live
feed cable which connects the meter to the
monitor. Any power you use in your home will
pass through this cable. The clip on sensor
relays the amount of current being drawn in the
home to the transmitter. From there it is sent
wirelessly to the energy monitor, which shows
how much power is being consumed.
It also includes:
1 x Instruction manual for the monitor
1 x Quick Start Guide
Wireless Energy Monitor
Mini CT Sensor Transmitter
PRIOR TO INSTALLATION
The efergy elite is installed by clipping the mini CT sensor around the feed wire of your electric
panel. In Australia the standard residential voltage is 240V.
Note - For a 240V panel (typical residential electric panel) power is measured using one mini CT
sensor. For different voltages, please change during the Monitor Setup stage (see page 13).
Installation for Three Phase Panels
The elite is installed by clipping the mini CT sensor around the feed wire of your electric panel.
In the case of a commercial or industrial three phase panel or service, you must use three mini
CT sensors to measure all three phases. Simply order an additional two mini CT sensors from
your dealer. Identify the three power wires providing service to your electric panel. Open and
place one sensor around each of the three main feed wires.
Installing Transmitter for Three Phase
Plug the three mini CT sensor cables into the transmitter. Mount the transmitter on the wall next
to the electric panel. This will make it easier to replace the batteries. Readings for a three phase
system may not be accurate depending on connection and loading system.
WE RECOMMEND THAT THE EFERGY MONITOR IS INSTALLED BY A LICENSED ELECTRICIAN