User Guide

6 Channel Mic/Line Mixer

TX6000

Description

The TX6000 is a high specification, single rack space, 6 channel mic/line mixer suitable for desk

or rack mounting. The mixer is designed to operate from both AC mains power as well as 24

volts DC.

Inputs

Six dual mic/line inputs are provided. The mic inputs are active balanced and feature 3 pin XLR

female sockets. Each channel also includes dual female RCA line/aux sockets.

Outputs

The TX6000 features a balanced line output via a 3 pin XLR male socket. A mono tape output

is also available via dual female RCA sockets. A 1/4” mono headphone socket is included on

the front panel.

Controls

Front panel controls include a master output level control plus overall bass and treble controls.

Individual channel level controls are provided for all six inputs.

Metering

A 7 segment LED meter is provided for the master output. A power “on” LED is also included.

Muting

Muting is available via the optional VOX operated plug-in TX3010 or TX3014 precedence

cards. The TX3010 provides priority from channel 1 over all other channels. The TX3014 pro-

vides two levels of priority. Channel 1 is the master mute channel and overrides channels 2-6,

whereas channels 2 will mute channels 3-6 only.

Tone Generators

The ATC5488 is an optional plug-in accessory providing 4 tones (Bell, Pre-Announce Chime,

Alert and Evacuate). The evacuate and alert tones comply with Australian Standard AS2220.1.

The ATC5488 plugs into the main board via a 7 pin connector. Activation wires can be fed

through a rear panel slot below the 24V DC connector. Each tone can be activated by a sim-

ple contact closure.

Phantom Power

Phantom power (18V DC) is provided on all mic inputs.

PAGE 1
Description The TX6000 is a high specification, single rack space, 6 channel mic/line mixer suitable for desk or rack mounting. The mixer is designed to operate from both AC mains power as well as 24 volts DC. TX6000 6 Channel Mic/Line Mixer Inputs Six dual mic/line inputs are provided. The mic inputs are active balanced and feature 3 pin XLR female sockets. Each channel also includes dual female RCA line/aux sockets. Outputs The TX6000 features a balanced line output via a 3 pin XLR male socket.
PAGE 2
Frequency Response 50Hz - 15kHz (± 3dB) Total Harmonic Distortion Less than 0.08% @ 1kHz Signal To Noise Ratio Tone Controls -78dB (all channels at centre position) Bass @ 100Hz, Boost +12dB, Cut -12dB; Treble @ 10kHz, Boost +9dB, Cut -9dB Inputs 6 dual mic/line. The mic inputs are active balanced with 3 pin XLR female sockets (200-600 Ohms). Maximum input level is 100mV. The line inputs are dual female RCAs (47K Ohms). Maximum input level: 2.5V/10V Input Sensitivity Mic: 0.