User's Manual

7 Operation

7.1 Battery

The Air series' transmitting units can only be powered through Autec

rechargeable batteries.

See the battery charger manual enclosed in the packaging with the battery

charger for any warnings and instructions regarding the batteries.

7.1.1 Battery insertion

Push the battery towards the contacts on the transmitting unit (1) and insert it inside the

housing (2).

7.1.2 Battery removal

Push the battery towards the contacts on the transmitting unit (3) and remove it from the

housing (4).

7.1.3 Battery run time indicator

Perform the following procedure to check the run time of the battery in the transmitting unit:

1. switch o󰘯 the transmitting unit and unlock the STOP pushbutton

2. activate the S1 command (check in the technical data sheet which actuator it corresponds

to) and press the START pushbutton until the LED indicating the battery level illuminates:

- 1 LED on: low level

- 2 LEDs on: medium level

- 3 LEDs on: maximum level.

Run time indication disappears after some seconds.

LIAJSE00-00

Operation

AUTEC - Air series