User's Manual

Address storage
When the battery is charged and the Air-KEY is in the "BACK-UP UNIT", perform the following
procedure to store the address:
1. press the START pushbutton until the green and the red LEDs illuminate and an acoustic
signal sounds
2. wait until the green LED blinks slowly
3. within 3 seconds, activate in sequence the commands corresponding to PIN 1, PIN 2 and
PIN 3 that compose the PIN code given in the technical data sheet.
If the PIN code is incorrect, the red LED illuminates and the transmitting unit switches o󰘯. In
this case, the storage procedure shall be repeated.
If the PIN code is correct, the green LED turns steady on and the transmitting units switches
o󰘯: this indicates that the address has been stored in the "BACK-UP UNIT". It is now
possible to start the radio remote control and control the machine with the "BACK-UP UNIT"
transmitting unit.
7.3 START pushbutton
The START pushbutton is used to:
- start the radio remote control (see paragraph 6.1)
- activate the horn when the radio remote control is started.
7.4 STOP pushbutton
The STOP pushbutton should be pressed when it is necessary to immediately
stop the machine when a dangerous condition occurs.
When the STOP pushbutton is pressed, the machine stops and
the transmitting unit switches o󰘯.
To start working again after the STOP pushbutton has been
pressed:
1. make sure that the working and usage conditions are safe
2. turn the STOP pushbutton in the arrow direction to unlock it
3. start the radio remote control (see paragraph 6.1).
12
LIAJSE00-00
Operation
AUTEC - Air series