User's Manual

Values of proportional outputs
AUTEC Dynamic Series
LIARME01-00.fm Part D: ARM receiving unit
D - 9
ENG
6.3 Inversion of movement direction of the joystick's axis
1. Start up the radio remote control.
2. Press the TEACH pushbutton in the receiving unit and do not release it until
the SETUP LED illuminates.
3. Activate and release the “TEACH +” command related to the corresponding
switch on the transmitting unit.
4. Press and release the START pushbutton.
5. Repeat actions described in points 3. and 4. until the SETUP LED on the re-
ceiving unit starts blinking four times.
6. Set the desired values as follows:
- Move the joystick out of the rest position of the axis to be calibrated. Main-
tain this position and activate once the “TEACH +” command related to the
corresponding switch on the transmitting unit.
- After calibrating one joystick in the transmitting unit, press the STOP push-
button to save calibrations. Calibrations are saved in the data memory on
the DTK connector.
- To set other values, unlock the STOP pushbutton, press the START push-
button and repeat actions described in point 6..
7. To leave the procedure, press the TEACH pushbutton on the receiving unit
and do not release it until the SETUP LED switches off.
6.4 Restoring factory settings
This procedure is used to restore factory settings for the proportional outputs.
1. Ensure that the transmitting unit is switched off.
2. Power on the receiving unit.
3. Press the TEACH pushbutton and do not release it until the SETUP LED illu-
minates.
4. Press the TEACH pushbutton three times and do not release it at last pres-
sure; the SETUP LED blinks fast: this indicates that factory settings are being
restored.
5. Release the TEACH pushbutton when the SETUP LED is steadily illuminated
again.
If the TEACH pushbutton is released before the SETUP LED is steadily illumi-
nated, factory settings of proportional outputs will not be restored.
6. To leave the procedure, press the TEACH pushbutton on the receiving unit
and do not release it until the SETUP LED switches off.