User's Manual

4.3 Use
The use of industrial radio remote controls is strictly limited to skilled and properly trained
personnel.
When the radio remote control is installed on machines on board vehicles,
switcho󰓐thereceivingunitwhilethevehicleistravelling.
All warnings for correct use are given in chapter 3.
All instructions for correct use are given in chapters 5 and 6.
Environmental working conditions are given in the following table.
Temperature Relative Humidity Air pressure
Use
of the
transmitting
unit
Class 5K4H
-25°C to +55°C
(-13°F to +130°F)
Class 5K2
5% to 95%
Class 5K2
70kPa to 106kPa
Use
of the receiving
unit
Class 5K2
-25°C to +70°C
b
(-13°F to +158°F)
b. The receiving unit can work at 70°C (185°F) only if the sum of currents corresponding to the loads
simultaneously activated by digital and analogue outputs does not exceed 10A.
4.4 Radio remote control maintenance
The following instructions provide information to safely carry out routine and special
maintenance operations for the radio remote control.
They shall be completed by:
- instructions provided by the machine manufacturer
- directions provided by the installer of the radio remote control on the machine
- regulations regarding safety at work and accident prevention in force in the country where
the radio remote control is used.
All 󰘰ne-tuning, checking and maintenance actions carried out on the radio remote control shall
be veri󰘰ed and recorded by the person in charge of carrying out maintenance on the machine.
16
LIDYNE00-04
Radio remote control life cycle
AUTEC - Dynamic Series