User's Manual

Before any maintenance operation, remove the battery from the transmitting
unit and disconnect power supply from the receiving unit.
After each maintenance operation, always make sure that all commands sent
by the transmitting unit only activate the corresponding expected operations.
In case of malfunction or damaged parts, disable the system “machine+radio
remote control” until the problem has been completely solved.
After each maintenance operation, if a unit has been opened, close it
correctly, in order not to endanger its protection degree from dust and
water: check that the gasket is intact, correctly overlay the two parts of the
housing and tighten the screws.
4.4.1 Routine maintenance
Routine maintenance consists of operations needed to preserve the radio remote control
normal usage conditions, thus implementing 󰘰ne-tuning, checks, planned replacement actions
that necessarily arise from the normal use of the product.
All given instructions must be followed correctly at each commissioning, that is:
- whenever the radio remote control and/or the machine is installed or assembled
- whenever the machine location/position changes
- after special maintenance.
Routine maintenance carried out as described in this manual is fundamental for using the
radio remote control safely.
Special applications may need more speci󰘰c routine maintenance actions to be carried out at
di󰘯erent periods (i.e. if the working environment is particularly dirt, in case of heavy applications
or if the system is used very frequently, some maintenance actions may be required more
frequently, depending on the decision of the person in charge for safety in the work site).
4.4.2 Daily routine maintenance
Before starting to work:
- make sure that the transmitting unit panel symbols can be easily recognised and replace
the panel if necessary
- check that the three plates on the transmitting unit are readable and intact
- make sure that the mechanical operation of the STOP pushbutton is correct.
AUTEC - Dynamic Series
Radio remote control life cycle 17
LIDYNE00-04