User's Manual
5 General operating instructions
5.1 Starting up the radio remote control
Starting up the radio remote control consists in building a radio link between the transmitting
and the receiving unit. For this purpose, you need to:
1. power on the receiving unit respecting the voltage limits provided in the technical data.
The POWER LED switches on
2. insert a charged battery in the transmitting unit (see paragraph 6.1)
3. insert the S-KEY in the transmitting unit and turn it
4. press the START pushbutton in the transmitting unit until the POWER LED in the receiving
unit and the green LED in the transmitting unit start blinking slowly.
5.2 Command activation
With the radio remote control started, act on the joysticks, pushbuttons and switches
corresponding to the command to be performed.
The user must be properly trained about the symbols on the transmitting unit panel, to be
aware of the matching between actuators and movements on the machine (symbols used are
dened by the machine manufacturer according to the functions of the machine).
The transmitting unit can have some specic commands (see paragraph 6.5).
5.3 Data Feedback Function
The user receives information and/or signals concerning the controlled machine by means
of the Data Feedback function.
During normal radio remote control operation, pay particular attention to the indications
displayed and signalled by the display or through the LEDs: they can be helpful to evaluate
the machine working status.
Any information shown and signalled on the display or through the LEDs
can never be considered or used as a safety signal or for legal metrology.
When operating and moving the machine, remember that the radio remote
control does not intervene autonomously when potential hazardous situations
are displayed and signalled.
AUTEC - Dynamic Series
General operating instructions 21
LIDYNE00-04