User's Manual
5.3.1 Operation with display
If the transmitting unit has a display, it is possible to visualise signal icons, measurements
collected from the machine and their description.
Information displayed and how it is displayed (icons and/or measurements and/or descriptions)
depend on the settings chosen by the machine manufacturer.
In addition, two indicators are always present:
- battery charge level (at the bottom on the left)
- quality of radio link (at the bottom on the right).
5.3.2 Operation with LED
If the transmitting unit has an LED array, particular machine conditions are signalled if they
are on (i.e. load limits, limit switch, …).
The signalled conditions depend on the settings chosen by the machine manufacturer.
5.4 Radio link interruption
When the radio link is incorrect or interrupted for a certain period of time, the passive stop
function automatically cuts in (see paragraph 1.6.1).
The green LED on the transmitting unit switches from blinking slowly to fast blinking.
The POWER LED on the receiving unit switches from blinking to steady on.
Press the START pushbutton to start the radio remote control.
Please note that when the START pushbutton is pressed to start up the radio
remote control after the radio link had been interrupted, commands that
were enabled before the interruption are immediately activated. If this may
lead to a dangerous situation, press and then unlock the STOP pushbutton.
Only then, press the START pushbutton.
5.5 Transmittingunitautomaticswitcho
The transmitting unit automatically switches o when:
- the battery is at (see paragraph 5.5.1)
- the radio remote control is not used for a certain time (see paragraph 5.5.2)
- the transmitting unit is powered and never switched o for eight hours non-stop (see
paragraph 5.5.3).
The green LED on the transmitting unit switches o.
The POWER LED on the receiving unit switches from blinking to steady on.
Press the START pushbutton to start the radio remote control.
22
LIDYNE00-04
General operating instructions
AUTEC - Dynamic Series