User's Manual
5.5.1 Low battery
The transmitting unit indicates if the battery is not suciently charged (the red LED blinks
and an acoustic signal sounds).
The transmitting unit automatically switches o after 3.5 minutes from the beginning of the
signal.
The battery needs to be replaced with a charged one (see paragraph 6.1).
5.5.2 When the transmitting unit is not used
If the transmitting unit remains started for a time equal to the “auto switch-o time” while none
of these commands is enabled: SAFETY, D2-D10, H1-H8 and L1-L8, then it automatically
switches o.
The activation of this function and its cut-in time are set by the machine manufacturer (see
technical data sheet).
5.5.3 Non-stop use
The transmitting unit indicates if it has been used for eight hours non-stop (the red LED blinks
and an acoustic signal sounds).
The transmitting unit automatically switches o after 3.5 minutes from the beginning of the
signal.
5.6 Switchingothetransmittingunit
The transmitting unit shall be switched o each time work is stopped: remove the S-KEY
(see paragraph 6.2) and always store it in a safe place.
5.7 Switchingothereceivingunit
The receiving unit shall be switched o each time the radio remote control is not used to
control the machine. Remove power from the unit to switch it o.
When the radio remote control is installed on machines on board vehicles,
switchothereceivingunitwhilethevehicleistravelling.
AUTEC - Dynamic Series
General operating instructions 23
LIDYNE00-04