User's Manual

6.7 Cable control
The wire control is used:
- in particular working conditions, established by the machine manufacturer
- when it is not possible to build a radio link between the radio remote control units
- when working in environments where using radio frequencies is not allowed or is dangerous
- when a fully charged battery is not available.
When using the wire control, it is not possible to eliminate the electric shock
hazard when working near in-ground or overhead high voltage electrical
cables.
6.7.1 Description
The wire control connects the transmitting unit to the receiving unit through a cable that
replaces the radio link. The cable shall be plugged in the suitable connectors, one on the
transmitting unit and the other on the receiving unit (or placed where established by the
machine manufacturer).
When using the wire control, the working features do not change (i.e. the meaning of actuators
and the Data Feedback function).
6.7.2 Operation
Before starting to work, make sure that the cable and the corresponding
connectors are intact.
The wire control can only be connected and disconnected when the transmitting unit is
switched o󰘯.
After connecting or disconnecting the wire control, start up the radio remote control (see
paragraph 5.1). to control the machine.
During operation with wire control:
- radio link is o󰘯
- leave the battery inside the transmitting unit, even though the power supply comes from
the receiving unit. The battery is not, in any case, recharged through the wire control:
it can only be recharged through its appropriate battery charger provided together with
the system.
When you 󰘰nish working with the wire control, disconnect the cable from the
transmitting unit and from the machine, and protect the connectors with their caps.
AUTEC - Dynamic Series
Operation 29
LIDYNE00-04