User's Manual

1.5 Classi󰄈cationofcommands
Commands sent by the transmitting unit are classi󰘰ed according to their type.
1.5.1 Command type: analogue, digital or direction command
Commands sent by the transmitting unit can either be analogue or digital.
Analogue commands generate proportional outputs as a function of the position of the
corresponding actuator.
Digital commands switch the status of their corresponding output, according to the position
of the related actuator. This status can either be on or o󰘯.
Direction commands are digital commands paired with analogue commands, and are used
to specify the movement direction.
1.5.2 Name of commands
All commands sent by the transmitting unit are identi󰘰ed by abbreviations, which are also
written in the technical data sheet to highlight the match between commands sent and
machine functions.
The names of outputs in the receiving unit are not the names of commands. Check the
technical data sheet to know which name they were given.
1.6 Safety functions
Autec radio remote controls are equipped with some functions that provide high safety levels,
in order to safeguard the safety of people and property.
1.6.1 Stop function
The stop function brings the machine to a safe state every time it is necessary to stop it due
to a potentially hazardous situation. This function is either voluntarily enabled by the user
(active stop), as appropriate, or it cuts in automatically and autonomously (passive stop).
Active stop
Active stop is a function enabled by the STOP pushbutton (see paragraph 6.4) .
The transmitting unit sends to the receiving unit a command that immediately stops the
machine. When the STOP pushbutton is pressed, the machine stops in shorter time than
when passive stop cuts in.
Passive stop
Passive stop is a function that cuts in when a fault occurs during operation. When the radio
link is incorrect or interrupted, the receiving unit autonomously stops the radio remote control.
The cut-in time of this function (passive stop cut-in time) is set by the machine manufacturer
(see technical data sheet).
AUTEC - Dynamic Series
Radio remote control description 9
LIDYNE00-04