Instruction Manual
LIUDPP000_eng-00AUTEC
31
6.4 Warnings for inallation
The Inaller of the Radio Remote Control mu always read, underand and follow all the
inructions and warnings contained in this Manual. These inructions and warnings are not
exhauive. In addition, for a correct inallation, the Inaller mu abide and comply with all
Laws, Regulations and Standards, even local, including all the technical specifications and
andards applicable to the Autec Radio Remote Control to which this Manual applies (by way
of example: IEC 60204-1, IEC 60204-32). The Inaller of the Radio Remote Control mu also
observe all the inructions, provisions and technical directions provided by the Machine
Manufacturer.
Inructions and warnings provided in this chapter 6 are general. Specific inructions
for the inallation of the Radio Remote Control are provided in the Inallation
Manual: please refer to it for this information. The Inaller mu use and comply
with that Inallation Manual to complete the tasks for which he is appointed.
6.4.1 General warnings for inallation
Always follow the inructions provided in the Technical Data Sheet and
respect values given in the technical data to carry out correct inallation.
The electrical connection of the Receiving Unit mu meet the requirements
set by clause 9.1 of andard IEC 60204-1 and/or andard IEC 60204-32.
ONLY QUALIFIED PERSONNEL MAY INSTALL THE RADIO REMOTE CONTROL.
SUCH PERSONNEL MUST HAVE MASTERED THE TECHNICAL KNOWLEDGE
REQUIRED TO CARRY OUT THESE PROCEDURES CORRECTLY AND SAFELY
AND BE QUALIFIED ACCORDING TO THE APPLICABLE LAWS AND
REGULATIONS AND HAVE ALL NECESSARY CERTIFICATIONS.
FAILURE TO INSTALL THE AUTEC RADIO REMOTE CONTROL CORRECTLY
MAY RESULT IN PERSONAL INJURY OR DEATH, OR PROPERTY DAMAGE.