User's Manual

AUTEC - Dynamic series
Operation 27
LIDYNE00-05
6.5 Command meaning
Commands on the transmitting unit are established according to the machine's operations
and functions. They are established by the machine manufacturer, who also chooses the
symbols used.
Some of the commands available on the transmitting unit may be those described in the
following paragraphs; in this case, symbols used are generally those given here:
6.5.1 RPM+/- (during normal operation)
This switch increases (rpm +) or decreases (rpm -) the engine revolutions of the remote
controlled machine.
6.5.2 TEACH (during REMOTE SETUP)
This switch is used to calibrate minimum and maximum values of proportional outputs.
6.5.3 MOVEMENT SPEED SELECTOR
This switch is used to modify the movement speed
According to the con󰘰guration:
- it sets two or three speed levels
- it increases and/or decreases speed.
These three symbols are used:
Symbol Meaning
This symbol indicates the typical machine's speed.
This symbol indicates a reduction in the machine's speed (the reduction is set by
the manufacturer).
This symbol, if present, indicates a further reduction in the machine's speed (the
reduction is set by the manufacturer).