User's Manual
AUTEC LIUDJM000_eng-00
WARNING
THIS PART OF THE MANUAL CONSISTS OF: Part C - Information, instructions and
warnings for the DJM Transmitting Unit. The Manual consists of Part A – General, Part
B – Conformity and Frequencies, Part C – Transmitting Unit, Part D – Receiving Unit
and Part E – Battery and Battery Charger, plus the Technical Data Sheet.
THIS MANUAL, INCLUDING ALL PARTS OF THIS MANUAL, AND ALL INSTRUCTIONS
CONTAINED HEREIN, MUST BE READ CAREFULLY AND UNDERSTOOD BEFORE
INSTALLING, USING, MAINTAINING OR REPAIRING THE AUTEC RADIO REMOTE
CONTROL.
FAILURE TO READ AND COMPLY WITH ALL APPLICABLE WARNINGS AND
INSTRUCTIONS OR ANY ONE OF THE LIMITATIONS NOTED IN THIS MANUAL CAN
RESULT IN SERIOUS BODILY INJURY OR DEATH, AND/OR PROPERTY DAMAGE.
THE AUTEC RADIO REMOTE CONTROL IS NOT A STANDALONE PRODUCT AND IS
INTENDED ONLY AS A COMPONENT ON A MACHINE:
- ON WHICH AND WHERE THE USE OF A RADIO REMOTE CONTROL IS APPROPRIATE,
- THAT CAN BE OPERATED SAFELY AND IN ACCORDANCE WITH ALL APPLICABLE
LAWS, REGULATIONS AND STANDARDS BY SUCH REMOTE CONTROL.
ACCORDINGLY, IT IS THE RESPONSIBILITY OF THE MANUFACTURER OF THE MACHINE
ON WHICH THE AUTEC RADIO REMOTE CONTROL IS TO BE INSTALLED, AND ITS
DESIGN PROFESSIONALS, that a full and proper risk assessment is done to determine
whether the use and installation of the Autec Radio Remote Control is appropriate for
the safe and eective operation of the Machine by a Radio Remote Control in the facility
and for the purposes intended, and that the installation, maintenance and operation
of the Autec Radio Remote Control and all of its components are done solely and
completely in accordance with this Manual, and with all local applicable laws, safety
rules and standards (all of the foregoing referred to herein as “Laws, Regulations and
Standards”).
With reference to the USA market the Laws, Regulations and Standards include all safety
rules and regulations of the Occupational Safety & Health Administration (OSHA) (http://
www.osha.gov), all federal, state and local laws, regulations and building and electrical
codes, and all applicable standards, including but not limited to ANSI Standards.
It is also the responsibility of the Manufacturer of the Machine on which the Autec
Radio Remote Control is to be installed and used, and their design professionals, to
be certain that the structure, condition, organization and markings of the Machine as
installed at the facility is appropriate for and will allow for the safe and reliable use and
control of the Machine through the Autec Radio Remote Control interface.