User's Manual

AUTEC - Dynamic Plus series
Frequencies 15
LIUDT1001_eng-00
4.1.4 Countries of usage
Dynamic Plus series' Radio Remote Controls working in the 863-870MHz frequency band can
be used within the EU (European Union) and the EFTA (European Free Trade Association).
Check on the technical data plate of the Units in which markets the Radio Remote Control
can be used.
4.2 Frequency band 915-928MHz
4.2.1 Frequencies
The radio link between the Units of Autec Dynamic Plus series Radio Remote Controls is
established at one of the frequencies permitted by the USA and Australian standards in force
when the system is put on the market.
Frequencies used in the band 915-928MHz ................................................................ 255
RF power (FCC and IC) ................................................... meets FCC and IC requirements
Channel spacing ...................................................................................................... 50kHz
Dynamic Plus series Radio Remote Controls communicate either in dynamic or static mode.
Mode is decided by the Machine Manufacturer.
4.2.2 Dynamic mode
A Radio Remote Control communicating in dynamic mode:
- uses a working frequency in the 915-928MHz band,
- checks that the frequency is free before using it,
- continually changes the working frequency to maintain the radio link even when interference
occurs.
4.2.3 Static mode
A Radio Remote Control communicating in static mode:
- uses a working frequency in the 915-928MHz band,
- checks that the frequency is free before using it,
- always works at the same frequency until the stop function is activated.
4.2.4 Countries of usage
Dynamic Plus series' Radio Remote Controls working in the frequency band 915-928MHz
can be used in the USA and Australian markets.
Check on the technical data plate of the Units in which markets the Radio Remote Control
can be used.