User's Manual

24
LIUDTH000_eng-00
Installation
AUTEC - Dynamic Plus series
6 Installation
The chapter "Installing the Receiving Unit" in "Part D" of the Instruction Manual contains the
warnings for the installation that add to those provided in this chapter. Therefore, please
refer to that part of the Manual.
6.1 Applications
An Autec Dynamic Plus series' Radio Remote Control can be used for several applications:
the Machine's Manufacturer must establish if the Radio Remote Control is suitable for each
di󰘯erent application, with speci󰘰c regard to safety. The Dynamic Plus series is used most
frequently for the following type of Machines:
- Machines for lifting and moving materials, objects, general loads (by way of example:
hydraulic cranes, concrete pumps),
- Machines for raising and moving people (by way of example: elevated work platforms,
telehandlers),
- Drilling Machines.
The Autec Radio Remote Control may not be installed on Machines where
it is used for applications or functions not permitted under this Manual and
applicable Laws, Regulations and Standards, even local. INSTALLATION OF
AN AUTEC RADIO REMOTE CONTROL ON OTHER MACHINE OR FOR OTHER
FUNCTIONS MAY CAUSE SERIOUS INJURY OR DEATH OR PROPERTY
DAMAGE.
Autec is not and cannot be held responsible if the Radio Remote Control
is used in unsafe or poor safety conditions. Assessment shall be made
by the Machine Manufacturer to establish possible additional protection
measures for the actuators (by way of example: commands requiring two-
hand operation, “dead-man” function) if particular environments, equipment
and working modes could cause accidental bumps to the actuators.