User's Manual

AUTEC - Dynamic Plus series
Installation 27
LIUDTH000_eng-00
6.4 Warnings for installation
The Installer of the Radio Remote Control must always read, understand and follow all the
instructions and warnings contained in this Manual. These instructions and warnings are not
exhaustive. In addition, for a correct installation, the Installer must abide and comply with all
Laws, Regulations and Standards, even local, including all the technical speci󰘰cations and
standards applicable to the Autec Radio Remote Control to which this Manual applies (by
way of example: IEC 60204-1, IEC 60204-32). The Installer of the Radio Remote Control
must also observe all the instructions, provisions and technical directions provided by the
Machine Manufacturer.
Instructions and warnings provided in this chapter 6 are general. Specific
instructions for the installation of the Radio Remote Control are provided in the
Installation Manual: please refer to it for this information. The Installer must use
and comply with that Installation Manual to complete the tasks for which he is
appointed.
6.4.1 General warnings for installation
Always follow the instructions provided in the Technical Data Sheet and
respect values given in the technical data to carry out correct installation.
The electrical connection of the Receiving Unit must meet the requirements
set by clause 9.1 of standard IEC 60204-1 and/or standard IEC 60204-32.
ONLY QUALIFIED PERSONNEL MAY INSTALL THE RADIO REMOTE
CONTROL. SUCH PERSONNEL MUST HAVE MASTERED THE TECHNICAL
KNOWLEDGE REQUIRED TO CARRY OUT THESE PROCEDURES CORRECTLY
AND SAFELY AND BE QUALIFIED ACCORDING TO THE APPLICABLE LAWS
AND REGULATIONS AND HAVE ALL NECESSARY CERTIFICATIONS.
FAILURE TO INSTALL THE AUTEC RADIO REMOTE CONTROL CORRECTLY
MAY RESULT IN PERSONAL INJURY OR DEATH, OR PROPERTY DAMAGE.