User's Manual
AUTEC - Dynamic Plus series
Installation 33
LIUDTH000_eng-00
6.4.5 At the end of installation
Make sure that during installation the protection measures on the Radio
Remote Control and/or in the Machine have not been made ineective by
improper installation works.
Look up in the Technical Data Sheet and check that the frequency band set
in the Radio Remote Control is permitted in the country of use.
6.4.6 Testing
The Installer must check and complete the Technical Data Sheet in all its parts,
adding the date the system has been put into service, his stamp and signature.
After installing and wiring the Receiving Unit, test the Machine controlled
by the Radio Remote Control and verify that the operations carried out
correspond exactly to the commands sent, including in particular but not
limited to the functionality of the STOP command.
Make sure that the SAFETY outputs (of UMFS function) only activate after
the Radio Remote Control has started, and when a movement command is
sent to the Machine.
In case of malfunction, disable the system “Machine+Radio Remote Control”
until the problem has been completely solved and the installation and
functionality is conrmed to be correct..