User's Manual
AUTEC - Dynamic Plus series
Maintenance 43
LIUDTH000_eng-00
In case of malfunction, switch o the Transmitting Unit and disconnect
power supply from the Receiving Unit: this way, the system "Machine+Radio
Remote Control" is disabled; it cannot be used until the problem has been
solved by implementing the necessary technical operations.
After each maintenance operation, if a Unit has been opened, close it
correctly, in order to maintain the protection degree from dust, contaminants
and water:
- make sure that the gasket is intact and correctly seated,
- check that the housing parts correctly t so that they overlap,
- tighten the screws.
9.2 Routine maintenance
Routine maintenance consists of operations needed to preserve the Radio Remote Control
normal usage conditions, thus implementing ne-tuning, checks, planned replacement actions
that necessarily arise from the normal use of the product.
All given instructions must be followed correctly at each commissioning, that is:
- whenever the Radio Remote Control and/or the Machine is installed or assembled,
- whenever the Machine location/position changes,
- after special maintenance.
Routine maintenance carried out as described in this Manual is fundamental for using the
Radio Remote Control safely.
Special applications may require more specic routine maintenance actions to be carried
out at dierent periods [by way of example: if the working environment is particularly dirty,
or temperature is very high or very low (see limits provided in paragraph 8.3), or in case of
heavy application, or if it is used very frequently, some maintenance actions may be required
more frequently depending on the instructions provided by the Machine Manufacturer and/
or by the Installer).
When carrying out maintenance on the Machine, always disconnect power
supply from the Receiving Unit. In the event of necessary maintenance
on the Machine (by way of example: welding), disconnect all the electrical
connections of the Receiving Unit.