User's Manual

AUTEC - Dynamic Series
Malfunction signalled by the transmitting unit 9
LIFJME00-06
7 Malfunction signalled by the transmitting unit
Use the light signals on the transmitting unit to identify the radio remote control malfunction.
If the problem persists after the suggested solution has been carried out, contact the support
service of the machine manufacturer.
Signals Possible reason Solutions
The green LED does
not switch on when the
START pushbutton is
pressed, even though
both the battery and the
power keyswitch are
inserted.
The battery is 󰘱at. Replace the battery with a charged one.
The green LED blinks
fast.
No radio link.
Bring the transmitting unit closer to the
receiving unit.
The red LED switches
on for 2 seconds and
then the unit switches
o󰓐.
The transmitting unit does
not work correctly.
Perform the procedure to save the
address
c
.
Contact the support service of the
machine manufacturer.
The red LED blinks
once during start up.
The STOP pushbutton is
locked or damaged.
Unlock the STOP pushbutton.
If this signal persists, contact the support
service of the machine manufacturer.
The red LED blinks
twice during start up.
At least one of the
actuators corresponding
to commands D2-D20
and SAFETY is activated
or damaged.
Bring the actuators to the rest position. If
this signal persists, contact the support
service of the machine manufacturer.
The red LED blinks
three times during start
up.
The battery is 󰘱at. Replace the battery with a charged one.
The red LED blinks four
times during start up.
At least one of the
actuators corresponding
to commands A1-A8, L1-
L8, H1-H8 and SAFETY
is activated or damaged.
Bring the actuators to the rest position. If
this signal persists, contact the support
service of the machine manufacturer.
c. Procedure to save the address
- press the STOP pushbutton
- press the START pushbutton and do not release it until the green LED switches o󰘯
- unlock the STOP pushbutton