User's Manual
22
LIDYNE00-07
General operating instructions
AUTEC - Dynamic Series
5 General operating instructions
5.1 Starting up the radio remote control
As required by standards IEC 60204-1 and IEC 60204-32, non authorised
use of the machine must be prevented.
The power keyswitch used to start up the radio remote control complies
with this requirement.
Starting up the radio remote control consists in establishing a radio link between the transmitting
unit and the receiving unit. For this purpose, you need to:
1. power on the receiving unit respecting the voltage limits provided in the technical data.
The POWER LED switches on
2. Insert a charged battery in the transmitting unit (see paragraph 6.1.1)
3. insert the power keyswitch in the transmitting unit (see paragraph 6.3.3)
4. press the START pushbutton in the transmitting unit until the POWER LED in the receiving
unit and the green LED in the transmitting unit blink slowly.
5.2 Command activation
With the radio remote control started, act on the joysticks, pushbuttons and switches
corresponding to the command to be performed.
The user must be properly trained about the symbols on the transmitting unit panel, to be
aware of the matching between actuators and movements on the machine (symbols used are
dened by the machine manufacturer according to the functions of the machine).
The transmitting unit can have some specic commands (see paragraph 6.6).