User's Manual
AUTEC - Dynamic Series
General operating instructions 23
LIDYNE00-07
5.3 Data Feedback Function
The user receives information and/or signals concerning the controlled machine by means
of the Data Feedback function.
During normal radio remote control operation, pay particular attention to the indications
displayed and signalled by the display or through the LEDs: they can be helpful to evaluate
the machine working status.
Any information shown and signalled on the display or through the LEDs
can never be considered or used as a safety signal or for legal metrology.
When operating and moving the machine, remember that the radio remote
control does not intervene autonomously when potential hazardous situations
are displayed and signalled.
5.3.1 Operation with display
If the transmitting unit has a display, it is possible to show signal icons, measurements
collected from the machine and their description.
The machine manufacturer chooses which information are displayed and the way they are
displayed (icons and/or measurements and/or descriptions).
In addition, two indicators are always present:
- battery charge level (at the bottom on the left)
- quality of radio link (at the bottom on the right).
5.3.2 Operation with LED
If the transmitting unit has an LED array, specic machine conditions are signalled if they
are on (i.e. load limits, limit switch, …).
The signalled conditions depend on the settings chosen by the machine manufacturer.
5.4 Radio link interruption
When the radio link is incorrect or interrupted for a certain period of time, the passive stop
function automatically cuts in (see paragraph 1.6.1).
The green LED on the transmitting unit switches from blinking slowly to fast blinking.
The POWER LED on the receiving unit switches from blinking to steady on.
Press the START pushbutton to start the radio remote control.
Please note that when the START pushbutton is pressed to start up the radio
remote control after the radio link had been interrupted, commands that
were enabled before the interruption are immediately activated. If this may
lead to a dangerous situation, press and then unlock the STOP pushbutton.
Only then, press the START pushbutton.