User's Manual

26
LIDYNE00-07
Operation
AUTEC - Dynamic Series
6 Operation
6.1 Battery
The Dynamic series' transmitting units can only be powered by Autec
rechargeable batteries.
See the battery charger manual enclosed in the packaging with the battery
charger for any warnings and instructions regarding the batteries.
6.1.1 Battery insertion
Push the battery towards the contacts on the transmitting unit (1) and insert it inside the
housing (2).
The battery slides easily into place and ensures that the positive (+) and negative
(-) poles are correctly connected only if it is inserted with the plate facing its
housing, so that the battery's contacts match the transmitting unit's contacts.
6.1.2 Battery removal
Push the battery towards the contacts on the transmitting unit (3) and remove it from the
housing (4).
When the transmitting unit is not in use, remove the battery if possible.
6.2 ID internal tx memory
The transmitting unit may require the "ID internal tx memory", where the radio remote control's
address is stored.The technical data sheet indicates if the "ID internal tx memory" is required.
When is required the "ID internal tx memory" is always required the mechanical key.