User's Manual

28
LIDYNE00-07
Operation
AUTEC - Dynamic Series
6.3.5 BACK-UP UNIT
If the main transmitting unit cannot be used because it has been lost or damaged, it can be
replaced with a transmitting unit called "BACK-UP UNIT".
It is identical to the unit that cannot be used anymore; the only di󰘯erence is the presence of
the plate “BACK-UP UNIT” on the battery housing.
Insert in the "BACK-UP UNIT" the “Key ID 0-1” or the “ID internal tx memory”
of the transmitting unit that cannot be used any longer and perform the
address storage procedure described below.
Address storage
With fully charged battery and power keyswitch in the "BACK-UP UNIT", perform this procedure:
1. press the STOP pushbutton
2. press the START pushbutton and do not release it until the green LED switches o󰘯
3. unlock the STOP pushbutton
It is now possible to start the radio remote control and control the machine with the "BACK-
UP UNIT" transmitting unit.
6.4 START pushbutton
The START pushbutton is used to:
- start up the radio remote control (see paragraphs 5.1, 5.4 and
5.5)
- activate the horn when the radio remote control is started.