User's Manual
30
LIDYNE00-07
Operation
AUTEC - Dynamic Series
6.6.2 TEACH switch (during REMOTE SETUP)
This switch is used to calibrate minimum and maximum values
of proportional outputs.
Symbol Meaning
This symbol identies the TEACH+ command.
This symbol identies the TEACH- command.
6.6.3 MOVEMENT SPEED SELECTOR
This switch is used to modify the movement speed.
Depending on the conguration:
- it sets two or three speed levels
- it increases and/or decreases speed.
Symbol Meaning
This symbol indicates the normal machine's speed.
This symbol indicates a reduction in the machine's speed (the reduction is set by
the manufacturer).
This symbol, if present, indicates a further reduction in the machine's speed (the
reduction is set by the manufacturer).