User's Manual
Table Of Contents
- Index
- 1 User manual
- 2 Documentation
- 3 Dynamic series description
- 4 Risk analysis
- 5 FJS transmitting unit
- 6 FJL transmitting unit
- 7 FJM transmitting unit
- 8 ARM receiving unit
- 9 Warnings
- 10 Radio remote control lifecycle
- 11 General operating instructions
- 12 Working
- 13 Values of proportional outputs
- 14 Data memory backup
- 15 Troubleshooting
FJM transmitting unit
Technical data
AUTEC - Dynamic Series
LIUDYN2AC0-00_eng.fm User manual
21
7.2 Technical data
Power supply (battery MBM06MH)................................................................. NiMH 7.2 V
Antenna ................................................................................................................... internal
Housing material ........................................................................................... PA 6 (20% fg)
Protection degree ..........................................................................................................IP65
Dimensions ......................................................... 310 x 210 x 190 mm [12.2’’ x 8.3’’ x 7.5’’]
Weight............................................................................................................2.5 kg [5.5 lbs]
Run time (at 20°C) ....................................................................................................... 11 h
Run time with Data Feedback (at 20°C) ..................................................................... 9.5 h
Run time with Low Power (at 20°C) ............................................................................. 14 h
Run time with Data Feedback and Low Power (at 20°C) ......................................... 12.5 h
7.3 Light signals
The FJM transmitting units may have two or four LEDs.
In both cases, two LEDs are always available, providing information regarding the
radio remote control.
- a green LED identified with
- a red LED identified with
The green LED ...
Meaning
... is off The transmitting unit is switched off.
... blinks fast
The transmitting unit is switched on and there is no
radio link.
... blinks slowly
The radio remote control is started and the radio link is
present.