User's Manual

ARM receiving unit
Light signals
AUTEC - Dynamic Series
LIUDYN2AC0-00_eng.fm User manual
27
6. SETUP LED (yellow)
The SETUP LED shows the status of the data memory and of the address key,
depending on the receiving unit's working status.
The SETUP LED ... Meaning
... is off The receiving unit works correctly.
... blinks once Error on the address key.
... blinks twice Error on the data memory.
... blinks three times
The receiving unit is storing the data set through the
REMOTE SET UP (see paragraph 13.1) or through
the “Data memory backup” (see chapter 14).
... blinks slowly A data memory is connected to the BKK connector.
... blinks fast
This signal has two meanings, depending on the cur-
rent working status:
- the receiving unit is restoring factory settings (see
paragraph 13.2)
- an error occurred during the “Data memory backup”
(see chapter 14).
... is on
The receiving unit is in REMOTE SET UP mode (see
paragraph 13.1).