User's Manual

AUTEC - Dynamic Series
User manual
Radio remote control lifecycle
Transportation and storage
30
10 Radio remote control lifecycle
To ensure a safe and long-lasting operation of Dynamic series industrial radio re-
mote controls, carefully follow the instructions provided for each stage of the
product lifecycle.
10.1 Transportation and storage
Radio remote controls must always be transported and stored inside their original
packing until they are installed on the machine.
Environmental transportation and storage conditions are given in the following ta-
ble.
10.2 Installation
The radio remote control can only be installed and tested by competent staff that
masters the technical knowledge required to carry out these procedures and is
qualified according to the regulation of the country where the radio remote control
is mounted.
Only if the radio remote control is installed correctly can it be used safely.
Always follow the instructions provided in the technical data sheet to carry
out correct installation.
Please contact the machine manufacturer or the person who decided upon
the installation of the radio remote control for instructions and warnings re-
garding the installation.
Instructions to calibrate the minimum and maximum values of proportional out-
puts are reported in chapter 13.
Temperature Relative Humidity Air Pressure
Transportation
Class 2K3
-40°C to +70°C
[-40°F to +158°F]
Class 2K3
95%
Class 2K3
70 kPa to 106 kPa
Storage
Class 1K5
-40°C to +80°C
[-40°F to +176°F]
Class 1K3
5% to 95%
Class 1K5
70 kPa to 106 kPa