User's Manual
Table Of Contents
- Index
- 1 User manual
- 2 Documentation
- 3 Dynamic series description
- 4 Risk analysis
- 5 FJS transmitting unit
- 6 FJL transmitting unit
- 7 FJM transmitting unit
- 8 ARM receiving unit
- 9 Warnings
- 10 Radio remote control lifecycle
- 11 General operating instructions
- 12 Working
- 13 Values of proportional outputs
- 14 Data memory backup
- 15 Troubleshooting
AUTEC - Dynamic Series
User manual
General operating instructions
Radio link interruption
36
11.3.1 Operation with display
If the transmitting unit has a display, it is possible to show signal icons, measure-
ments collected from the machine and their description.
Information displayed and how it is displayed (icons and/or measurements and/
or descriptions) depend on the settings chosen by the machine manufacturer.
In addition, two indicators are always present:
- battery charge level (at the bottom on the left)
- quality of radio link (at the bottom on the right).
11.3.2 Operation with LED
If the transmitting unit has an LED array, particular machine conditions are sig-
nalled if they are on (i.e. load limits, limit switch, …).
The signalled conditions depend on the settings chosen by the machine manu-
facturer.
11.4 Radio link interruption
When the radio link is incorrect or interrupted for a certain period of time, the pas-
sive stop function automatically cuts in (see paragraph 3.6.1).
The green LED on the transmitting unit switches from blinking slowly to fast blink-
ing.
The POWER LED on the receiving unit switches from blinking to steady on.
Press the START pushbutton to start the radio remote control.
11.5 Transmitting unit automatic switch off
The transmitting unit automatically switches off when:
- the battery is flat (see paragraph 11.5.1)
- the radio remote control is not used for a certain time (see paragraph 11.5.2)
- the transmitting unit is powered and never switched off for eight hours non-
stop (see paragraph 11.5.3).
The green LED on the transmitting unit switches off.
The POWER LED on the receiving unit switches from blinking to steady on.
Press the START pushbutton to start the radio remote control.
11.5.1 Low battery
The transmitting unit indicates if the battery is not sufficiently charged (the red
LED blinks and an acoustic signal sounds).
The transmitting unit automatically switches off after 3.5 minutes from the begin-
ning of the signal.
The battery shall be replaced with a charged one (see paragraph 12.1).