User's Manual
Table Of Contents
- Index
- 1 User manual
- 2 Documentation
- 3 Dynamic series description
- 4 Risk analysis
- 5 FJS transmitting unit
- 6 FJL transmitting unit
- 7 FJM transmitting unit
- 8 ARM receiving unit
- 9 Warnings
- 10 Radio remote control lifecycle
- 11 General operating instructions
- 12 Working
- 13 Values of proportional outputs
- 14 Data memory backup
- 15 Troubleshooting
General operating instructions
Switching off the transmitting unit
AUTEC - Dynamic Series
LIUDYN2AC0-00_eng.fm User manual
37
11.5.2 When the transmitting unit is not used
The transmitting unit automatically switches off after the “automatic switch off time”
has elapsed; during that time, the unit stays on without movement commands ac-
tivated.
The activation of this function and its cut-in time are set by the machine manufac-
turer (see technical data sheet).
11.5.3 Non-stop use
The transmitting unit indicates if it has been used for eight hours non-stop (the
red LED blinks and an acoustic signal sounds).
The transmitting unit automatically switches off after 3.5 minutes from the begin-
ning of the signal.
11.6 Switching off the transmitting unit
The transmitting unit shall be switched off each time work is stopped: remove the
S-KEY (see paragraph 12.2) and always store it in a safe place.
11.7 Switching off the receiving unit
The receiving unit shall be switched off each time the radio remote control is not
used to control the machine. Remove power from the unit to switch it off.
When the radio remote control is installed on mobile machines, switch off
the receiving unit when the vehicle travels.