User's Manual

Working
START pushbutton
AUTEC - Dynamic Series
LIUDYN2AC0-00_eng.fm User manual
39
As the radio remote control address is stored in the S-KEY, use it with ut-
most care to reduce risks that may result from incorrect handling.
If the main transmitting unit cannot be used because it has been lost or
damaged, the back-up transmitting unit can be used instead. In this case,
insert the S-KEY in the back-up unit. The back-up unit is identical to the
main unit; the only difference is the presence of the plate “BACK-UP UNIT”
on the battery housing.
12.3 START pushbutton
12.4 STOP
The STOP pushbutton should be pressed when it is necessary to stop the
machine immediately when a dangerous condition should occur.
When the STOP pushbutton is pressed, the machine stops
(active stop: see paragraph 3.6.1), and the transmitting unit
switches off.
To start working again after the STOP pushbutton has been
pressed:
1. make sure that the working and usage conditions are
safe
2. turn the STOP pushbutton in the arrow direction to un-
lock it
3. start up the radio remote control (see paragraph 11.1).
The START pushbutton is used to:
- start up the radio remote control (see paragraphs 11.1,
11.4 and 11.5)
- activate the horn when the radio remote control is start-
ed.