User's Manual
Table Of Contents
- Index
- 1 User manual
- 2 Documentation
- 3 Dynamic series description
- 4 Risk analysis
- 5 FJS transmitting unit
- 6 FJL transmitting unit
- 7 FJM transmitting unit
- 8 ARM receiving unit
- 9 Warnings
- 10 Radio remote control lifecycle
- 11 General operating instructions
- 12 Working
- 13 Values of proportional outputs
- 14 Data memory backup
- 15 Troubleshooting
AUTEC - Dynamic Series
User manual
Troubleshooting
Solutions in case of malfunction
50
The SETUP LED
blinks once.
Error on the address
key.
Contact the support service of the
machine manufacturer.
The SETUP LED
blinks twice.
Error on the data mem-
ory.
Replace the data memory on the DTK
connector with the backup data mem-
ory attached inside the cover (see
chapter 14).
The SETUP LED
blinks slowly.
A data memory is con-
nected to the BKK con-
nector.
If you are not performing a backup of
the data memory, remove the memo-
ry from the BKK connector (see
chapter 14).
Signals
Possible
reason
Solutions