Instruction Manual

LIUDP1002_eng-00 AUTEC

As required by the document "RSS-Gen — General Requirements and Information for the

Certification of Radio Apparatus", the following indications are valid for all the Receiving Units

li󰘵ed in the previous table.

Under Indu󰘵ry Canada regulations, this radio transmitter may only operate using an

antenna of a type and maximum (or lesser) gain approved for the transmitter by Indu󰘵ry

Canada. To reduce potential radio interference to other users, the antenna type and

its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.)

is not more than that necessary for successful communication.

This radio transmitter has been approved by Innovation, Science and Economic

Development Canada to operate with the antenna types li󰘵ed below, with the maximum

permissible gain indicated. Antenna types not included in this li󰘵 that have a gain

greater than the maximum gain indicated for any type li󰘵ed are 󰘵rictly prohibited for

use with this device.

Antenna type Antenna gain Antenna impedance

Autec 󰘵ylus λ/4 <2dBi 50 Ohm

Autec 󰘵ylus λ/4 with 5m

RG58

<2dBi 50 Ohm

Autec 󰘵ylus λ/4 with 20m

RG213/U

<2dBi 50 Ohm