Instruction Manual

LIUDP1002_eng-00AUTEC
17
4 Frequencies
Dynamic+P series' Radio Remote Controls can work in two different frequency bands: 863-
870MHz or 915-928MHz.
The Radio Remote Controls' working frequency is defined by market-specific laws
and 󰘵andards. In order for the sy󰘵em “Machine+Radio Remote Control” to be
compliant and therefore to be used, these laws and 󰘵andards mu󰘵 be respected:
if they are not, the Radio Remote Control cannot and mu󰘵 not be used.
Autec cannot be held responsible if the Radio Remote Control is set with frequencies
that are forbidden in the country of use.
4.1 Frequency band 863-870MHz
4.1.1 Frequencies
The radio link between the Units of Autec Dynamic+P series Radio Remote Controls is e󰘵ablished
at one of the frequencies permitted by the European 󰘵andards in force when the sy󰘵em is put
on the market.
Frequencies used 128
RF power <25mW ERP
Channel spacing 50kHz
The Units communicate with one another in dynamic mode, that is:
- They use a working frequency in the 863-870MHz band
- They check that the frequency is free before using it
- They continually change the working frequency to maintain the radio link even when
interference occurs.
4.1.2 Countries of usage
Dynamic+P series' Radio Remote Controls working in the 863-870MHz frequency band can
be used within the EU (European Union) and the EFTA (European Free Trade Association).
Check on the technical data plate of the Units in which markets the Radio Remote Control can
be used.