Instruction Manual

LIUPJQ001_eng-00 AUTEC
16
7.2 Acou󰄋ic signals
The Transmitting Unit has an acou󰘵ic signal device that activates when:
- The battery is nearly 󰘱at.
- The Transmitting Unit has been on for eight hours.
- The Transmitting Unit does not work correctly.
- During the Radio Remote Control 󰘵art-up, the STOP pushbutton is pressed or damaged.
- During the Radio Remote Control 󰘵art-up, the SAFETY command is activated (see Technical
Data Sheet).
- During the Radio Remote Control 󰘵art-up, one of the commands D2-D20 is activated (see
Technical Data Sheet).
- During the Radio Remote Control 󰘵art-up, one of the commands A1-A8 is activated (see
Technical Data Sheet).
- During the Radio Remote Control 󰘵art-up, one of the commands H1-H8 is activated (see
Technical Data Sheet).
- During the Radio Remote Control 󰘵art-up, one of the commands L1-L8 is activated (see
Technical Data Sheet).
- During the Radio Remote Control 󰘵art-up, the battery is 󰘱at.
The acou󰘵ic signal device activates whenever the red LED [A] illuminates. The meaning of the
red LED [A] lighting up and of the activation of the acou󰘵ic signal and possible actions to perform
are described in chapter 11.
The meaning of the acou󰘵ic signals cannot be modified.
8 General operating in󰄋ructions
8.1 Power keyswitch
The Transmitting Unit have a power keyswitch. It can either one of the following:
- Mechanical key (see paragraph 8.1.1).
- M-Key (see paragraph 8.1.2).
The Radio Remote Control cannot work if the power keyswitch is not inserted in the Transmitting
Unit.
8.1.1 Mechanical key
The mechanical key makes it possible to power the Transmitting Unit.
Inserting the mechanical key
Do the following to insert the mechanical key:
1. Insert the mechanical key into its receptacle.
2. Turn the mechanical key clockwise.