Instruction Manual

LIUPJQ001_eng-00 AUTEC

8.5.2 TEACH switch (during REMOTE SETUP)

This switch is used to:

- Set maximum and minimum values of proportional outputs (see

"Part D" in the In󰘵ruction Manual).

- Set values related to the re󰘵 position of proportional outputs (o󰘯set)

(see "Part D" in the In󰘵ruction Manual).

- Invert the movement direction of the joy󰘵ick's axis (see the

In󰘵allation Manual).

Symbol Meaning

This symbol identifies the TEACH+ command.

This symbol identifies the TEACH- command.

8.5.3 MOVEMENT SPEED SELECTOR

This switch is used to modify the speed of the Machine movements.

Depending on the configuration:

- It sets two or three speed levels.

- It increases or decreases speed.

The levels and the speed increase and decrease are chosen by the

Machine Manufacturer.

Symbol Meaning

Depending on the configuration, this symbol indicates:

- the normal speed of the Machine movements or

- the increase of speed of the Machine movements.

Depending on the configuration, this symbol indicates:

- the reduced speed of the Machine movements or

- the decrease of speed of the Machine movements.

If this symbol is present, it indicates that the speed of the Machine movements is

further reduced.