Instruction Manual

LIUPJQ001_eng-00AUTEC
THIS PART OF THE MANUAL CONSISTS OF: Part C - Information, in󰄋ructions and
warnings for the PJQ (Model J6P) Transmitting Unit. The Manual consi󰄋s of Part A –
General, Part B – Conformity and Frequencies, Part C – Transmitting Unit, Part D –
Receiving Unit, Part E – Battery and Battery Charger, plus the Technical Data Sheet.
THIS MANUAL, INCLUDING ALL PARTS THEREOF, AND ALL INSTRUCTIONS CONTAINED
HEREIN, MUST BE READ CAREFULLY AND UNDERSTOOD BEFORE INSTALLING, USING,
MAINTAINING OR REPAIRING THE AUTEC RADIO REMOTE CONTROL.
FAILURE TO READ AND COMPLY WITH ALL APPLICABLE WARNINGS AND INSTRUCTIONS
OR ANY ONE OF THE LIMITATIONS NOTED IN THIS MANUAL CAN RESULT IN SERIOUS
BODILY INJURY OR DEATH, AND/OR PROPERTY DAMAGE.
THE AUTEC RADIO REMOTE CONTROL IS NOT A STANDALONE PRODUCT AND IS
INTENDED ONLY AS A COMPONENT ON A MACHINE:
- ON WHICH AND WHERE THE USE OF A RADIO REMOTE CONTROL IS APPROPRIATE,
- THAT CAN BE OPERATED SAFELY AND IN ACCORDANCE WITH ALL APPLICABLE
LAWS, REGULATIONS AND STANDARDS BY SUCH REMOTE CONTROL.
ACCORDINGLY, IT IS THE RESPONSIBILITY OF THE MACHINE MANUFACTURER ON
WHICH THE AUTEC REMOTE CONTROL IS INTENDED TO BE INSTALLED, to perform
an in-depth and accurate risk assessment to determine if the Autec Radio Remote Control
is suitable for operating a Machine in conditions of safety and operational effectiveness,
taking into account the conditions of use, the intended uses and the reasonably
foreseeable incorrect ones, so that the in󰄋allation, maintenance and use of the Autec
Radio Remote Control, and all its components, are performed only and entirely in
compliance with this Manual and in accordance with all local regulations, safety 󰄋andards
and regulations (referred to herein as "Laws, Regulations and Standards").
With reference to the USA market the Laws, Regulations and Standards include all safety
rules and regulations of the Occupational Safety & Health Admini󰄋ration (OSHA) (http://
www.osha.gov), all federal, 󰄋ate and local laws, regulations and building and electrical
codes, and all applicable 󰄋andards, including but not limited to ANSI Standards.
It is also the responsibility of the Manufacturer and of the design professionals of the
Machine on which the Autec Radio Remote Control is to be in󰄋alled and used to be certain
that the 󰄋ructure, condition, organization and markings of the Machine as in󰄋alled at
the facility is appropriate for and will allow for the safe and reliable use and control of
the Machine through the Autec Radio Remote Control interface.