Instruction Manual

LIUDPP000_eng-00 AUTEC
28
6 In󰄋allation
The chapter "Installing the Receiving Unit" in "Part D" of the Instruction Manual contains the
warnings for the installation that add to those provided in this chapter. Therefore, please
refer to that part of the Manual.
6.1 Applications
An Autec Dynamic+P series' Radio Remote Control can be used for several applications: the
Machine's Manufacturer mu󰘵 e󰘵ablish if the Radio Remote Control is suitable for each different
application, with specific regard to safety. The Dynamic+P series is used mo󰘵 frequently for
the following type of Machines:
- Machines for lifting and moving materials, objects, general loads (by way of example: hydraulic
cranes, concrete pumps)
- Machines for raising and moving people (by way of example: elevated work platforms,
telehandlers)
- Drilling Machines.
The Autec Radio Remote Control may not be in󰄋alled on Machines where it
is used for applications or functions not permitted under this Manual and
applicable Laws, Regulations and Standards, even local. INSTALLATION OF
AN AUTEC RADIO REMOTE CONTROL ON OTHER MACHINE OR FOR OTHER
FUNCTIONS MAY CAUSE SERIOUS INJURY OR DEATH OR PROPERTY
DAMAGE.
Autec is not and cannot be held responsible if the Radio Remote Control is
used in unsafe or poor safety conditions. Assessment shall be made by the
Machine Manufacturer to e󰄋ablish possible additional protection measures
for the actuators (by way of example: commands requiring two-hand operation,
“dead-man” function) if particular environments, equipment and working
modes could cause accidental bumps to the actuators.
"Take & Release" Radio Remote Controls are not suitable to be used in
Machines requiring simultaneous consent from different Transmitting Units
to 󰄋art the Machine itself or to perform operations.