Instruction Manual
LIUDPP000_eng-00AUTEC
THIS PART OF THE MANUAL CONSISTS OF Part A - Information, inructions and general
warnings for the Autec Dynamic+P Series Radio Remote Control. The Manual consis
of Part A – General, Part B – Conformity and Frequencies, Part C – Transmitting Unit,
Part D – Receiving Unit and Part E – Battery and Battery Charger, plus the Technical Data
Sheet.
THIS MANUAL, INCLUDING ALL PARTS THEREOF, AND ALL INSTRUCTIONS CONTAINED
HEREIN, MUST BE READ CAREFULLY AND UNDERSTOOD BEFORE INSTALLING, USING,
MAINTAINING OR REPAIRING THE AUTEC RADIO REMOTE CONTROL.
FAILURE TO READ AND COMPLY WITH ALL APPLICABLE WARNINGS AND INSTRUCTIONS
OR ANY ONE OF THE LIMITATIONS NOTED IN THIS MANUAL CAN RESULT IN SERIOUS
BODILY INJURY OR DEATH, AND/OR PROPERTY DAMAGE.
THE AUTEC RADIO REMOTE CONTROL IS NOT A STANDALONE PRODUCT AND IS
INTENDED ONLY AS A COMPONENT ON A MACHINE:
- ON WHICH AND WHERE THE USE OF A RADIO REMOTE CONTROL IS APPROPRIATE,
- THAT CAN BE OPERATED SAFELY AND IN ACCORDANCE WITH ALL APPLICABLE
LAWS, REGULATIONS AND STANDARDS BY SUCH REMOTE CONTROL.
ACCORDINGLY, IT IS THE RESPONSIBILITY OF THE MACHINE MANUFACTURER ON
WHICH THE AUTEC REMOTE CONTROL IS INTENDED TO BE INSTALLED, to perform
an in-depth and accurate risk assessment to determine if the Autec Radio Remote Control
is suitable for operating a Machine in conditions of safety and operational effectiveness,
taking into account the conditions of use, the intended uses and the reasonably
foreseeable incorrect ones, so that the inallation, maintenance and use of the Autec
Radio Remote Control, and all its components, are performed only and entirely in
compliance with this Manual and in accordance with all local regulations, safety andards
and regulations (referred to herein as "Laws, Regulations and Standards").
With reference to the USA market the Laws, Regulations and Standards include all safety
rules and regulations of the Occupational Safety & Health Adminiration (OSHA) (http://
www.osha.gov), all federal, ate and local laws, regulations and building and electrical
codes, and all applicable andards, including but not limited to ANSI Standards.