Instruction Manual
LIUDPP000_eng-00 AUTEC
46
8.2.1 Before arting to work
Before arting the Radio Remote Control to work, the User mu be positioned
in a place that allows him:
- The direct control of the radio remote controlled Machine and of the load
movements, and, at the same time
- A safe position with regard to the operation of the radio remote controlled
Machine and/or the load movement, and with regard to other operations
and/or activities and/or processes taking place in the working place.
In addition to the above, when the cable control is used, the User mu position
themselves in a place that prevents them from umbling on the cable control's
cable and from being trapped/blocked by it.
Always check that the mechanical operation of the STOP pushbutton is correct.
If it is impossible or difficult to press this pushbutton, do not use the Radio
Remote Control.
Never art up or use the Transmitting Unit if the working conditions pose the
risk of losing balance or of tripping.
Start up the Transmitting Unit only to use it according to its intended use or
for operational needs (by way of example: maintenance, checks): improper
use may cause dangerous situations.
Never art up or use the Transmitting Unit in closed spaces, with no or poor
visibility, or outside the Radio Remote Control working range: in such cases
it is ill possible to eablish a radio link between the Transmitting Unit and
the Receiving Unit, thus causing the risk that unwanted commands be carried
out by the radio remote controlled Machine.
Get familiar with the relation between the actuators and the Machine's
movements (this is indicated in the attached Technical Data Sheet) and learn
symbols on the Transmitting Unit's panel (the used symbols are defined by
the Machine Manufacturer and/or by the Inaller depending on the effectiveness
and the functions the Machine requires).