Instruction Manual
LIUDPP000_eng-00 AUTEC
50
Before any maintenance operation, disconnect the Receiving Unit from the
power supply, using the devices and inructions provided by the Machine
Manufacturer and by the Inaller.
After each maintenance operation, always make sure that all commands sent
by the Transmitting Unit activate only the corresponding expected operations.
In case of malfunction, switch off the Transmitting Unit and disconnect power
supply from the Receiving Unit: this way, the syem "Machine+Radio Remote
Control" is disabled; it mu not be used until the problem has been solved
by implementing the necessary technical operations.
After each maintenance operation, if a Unit has been opened, close it correctly,
in order to maintain the protection degree from du, contaminants and water:
- Make sure that the gasket is intact and correctly seated.
- Check that the housing parts correctly t so that they overlap.
- Tighten the screws.