Instruction Manual
LIUDPP000_eng-00AUTEC
57
10 Troubleshooting
If the Radio Remote Control does not work correctly, carry out the following preliminary checks:
1. Move all other Transmitting Units in the working area away from the Autec Transmitting Unit in
use to avoid possible radio interference.
2. Bring the Autec Transmitting Unit closer to the matching Autec Receiving Unit to avoid possible
radio interference, always positioning yourself in a safe place and with full view of the Machine,
its operational area and the load, if any. In a "Take & Release" Radio Remote Control, if you
cannot take control of the Receiving Unit, even from a short diance, make sure that it is not
already controlled by the other Transmitting Unit.
3. Determine if the problem lies with the Radio Remote Control or with the Machine: to that
purpose, you need to try to control the Machine with another control ation (if any),dierent
from the Radio Remote Control. If the problem persis after this attempt, you need to x the
Machine: follow the inructions provided by the Machine Manufacturer. Otherwise, the
problem lies with the Autec Radio Remote Control, so you need to carry out further checks (see
paragraph 10.3).
10.1 Radio Remote Controls with "Data Feedback" function
It is ill possible that the Transmitting Unit sends commands to control the Machine even if the
Data Feedback function does not work properly (refer to "Data Feedback function" in "Part C"
of the Manual), or if there is no information and/or signals coming from it.
When the display or the LED array does not work, please contact the support
service of the Machine Manufacturer, even if none of the problems indicated
in paragraph 10.3 has been detected.
10.2 Radio Remote Controls with cable control
Possibly use the wire control to check if radio interference occurs.
On the contrary, if you want to check that the wire control works properly:
1. Connect the cable to the Transmitting Unit and to the Receiving Unit.
2. Check that the movement carried out by the Machine correspond to the commands sent by the
Transmitting Unit.
10.3 Solutions in case of malfunction
Look up in “Part C” and/or in “Part D” of the Manual to identify the Radio Remote Control
malfunction signalled by light signals on the Units.
If the problem persis after attempting the suggeed solution, contact the support service of
the Machine Manufacturer.