Instruction Manual
LIUDP1001_eng-00AUTEC
15
As required by the document "RSS-Gen — General Requirements and Information for the
Certification of Radio Apparatus", the following indications are valid for all the Receiving Units
lied in the previous table.
Under Indury Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Indury
Canada. To reduce potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.)
is not more than that necessary for successful communication.
This radio transmitter has been approved by Indury Canada to operate with the
antenna types lied below with the maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna types not included in this li,
having a gain greater than the maximum gain indicated for that type, are rictly
prohibited for use with this device.
Antenna type Antenna gain Antenna impedance
Autec ylus λ/4 <2dBi 50 Ohm
Autec ylus λ/4 with 5m
RG58
<2dBi 50 Ohm
Autec ylus λ/4 with 20m
RG213/U
<2dBi 50 Ohm