Instruction Manual

LIUPJQ000_eng-00AUTEC
43
11 Malfunction signalled by the Transmitting Unit
11.1 Red LED [B] and green LED [A]
The table below li󰘵s malfunctions that are signalled by LEDs on the Transmitting Unit and the
solution to those malfunctions.
If the problem persi󰘵s after attempting the sugge󰘵ed solution, contact the support service of
the Machine Manufacturer.
Signals Possible reasons Solutions
The green LED blinks fa󰘵.
The red LED blinks for 3.5
minutes.
The battery is not charged
enough or the Transmitting Unit
has been on for eight hours.
It is necessary to replace the
battery with a charged one (see
paragraph 8.7) or it is necessary
to switch off the Transmitting Unit
and to re-󰘵art the Radio Remote
Control.
The green LED repeats one of
the following sequences: ONE or
TWO blinks and a pause.
The red LED blinks for 3.5
minutes.
The green LED repeats the
sequence: three blinks and a
pause.
The red LED blinks for 3.5
minutes.
The Transmitting Unit has been
on for eight hours.
You need to switch off the
Transmitting Unit and 󰘵art the
Radio Remote Control again.
The green LED is off.
The red LED makes ONE very
long blink.
The Transmitting Unit does not
work correctly.
Contact the support service of
the Machine Manufacturer.
At Radio Remote Control 󰘵art
up, the green LED is off and the
red LED makes ONE long blink.
The STOP pushbutton is
pressed.
Unlock the STOP pushbutton.
At Radio Remote Control 󰘵art
up, the green LED is off and the
red LED makes TWO long blinks.
The Transmitting Unit does not
work correctly.
Contact the support service of
the Machine Manufacturer.